Table of Contents
Advertisement
Turning the radio on
Press the Power button (13, 24) to turn the device on. If the radio is not in radio
mode, press source (3, 29) until the display (14) shows "Rad". Once "Rad" has
disappeared, the frequency and the band (AM/FM) are shown on the display (14).
Switching between AM/FM
This device has an AM tuner with a frequency range from 522 kHz to 1620 kHz and
an FM tuner with a frequency range from 87,5 MHz to 108,0 MHz. Press the Band
button (12, 31) to switch between AM and FM.
Finding a station / frequency
You can use manual tuning or automatic tuning when searching for a radio station.
To automatically search for a station with a frequency higher than the current
frequency, hold the tun+ button (11, 34) for 3 seconds. To automatically search for a
station with a frequency lower than the current frequency, hold the tun- button (11,
34) for 3 seconds. Once the tuner has found a station with sufficient signal strength, it
will stop scanning automatically.
To manually switch frequency or to fine tune, briefly press the tun- button (11, 34) to
lower the frequency with steps of 9 kHz in AM or steps of 0,05 MHz in FM. Briefly
press the tun+ button (11, 34) to increase the frequency with steps of 9 kHz in AM or
steps of 0,05 MHz in FM.
Storing preset stations
You can store up to 30 stations in the memory. 10 AM stations and 20 FM stations.
Storing a station:
1. Press the memory button (4, 36). P01 will blink on the display (14). P is the
number of the preset station, which means the number that the station will be
saved under.
2. You can browse through the P numbers by pressing the mem- button (16, 33) or
mem+ button (15, 25).
3. Store a station by pressing the memory button (4, 36).
Recalling a preset station
You can recall a preset station by pressing mem- (16, 33) or mem+ (15, 25). When
using the AM band, only AM preset stations can be recalled. When using the FM
band, only FM preset stations can be recalled.
14
Advertisement
Table of Contents
