Switching Between Mono And Stereo; Playing A Cd; Basic Operation During Cd Playback; Usb Storage Device Playback - LENCO SCD-2000 BT User Manual

Switching between mono and stereo

Some channels can only be received in mono while some others might have bad
stereo reception, causing noise. When there is noise while receiving a stereo station,
the sound can be improved by switching to mono. Press the FM ST. Button (5, 26) to
switch between mix mono and stereo mode. When the device is in stereo mode,
"(ST)" will be shown on the display (14).

Playing a CD

Audio, MP3 and WMA CDs can be played with the built-in CD player. Enter the CD
mode by pressing the source button (3, 29) until CD is shown on the display (14).
Insert the CD in the disc slot (2) with the printed side facing the handle (1). The CD is
inserted at an angle of about 45 degrees. When the CD is inserted correctly into the
disc slot, the device will accept the CD and start reading it. Once the CD is read, the
device will automatically start playback. To eject the CD, press the eject button (6,
31). During CD playback, the display (14) will show the elapsed time of the track.

Basic Operation during CD playback

Pause playback,
playback. Press the play / pause button (15, 25) again to resume playback.
Stop playback, press the stop button (16, 33) during playback to stop playback.
Skip to next track,
track.
Skip 10 tracks, it is possible to skip 10 tracks at once. This can be done by pressing
the folder button (5, 26).
Fast Foward, hold the next button (11, 34) during playback to fast forward. Once the
button is released, the device will stop fast forwarding.
Skip to previous track,
the previous track.
Rewind, hold the previous button (11, 34) during playback to rewind. Once the button
is released, the device will stop rewinding.
Using the repeat function,
folder or all tracks on the media will be repeated. Press the play mode button (4, 36)
to enable the repeat function. The repeat mode can be changed or disabled by
repeatedly pressing the play mode button (4, 36). The display (14) will show the
active repeat mode as follows:
 REP 1: Current track is repeated.
 REP FOLDER: Current folder is repeated (Only for MP3 and WMA media with
multiple folders).
 REP ALL: All tracks on media are repeated.

USB storage device playback

Through the built-in USB port (9) MP3 and WMA files can be played. Enter the USB
mode by pressing the source button (3, 29) until USB is shown on the display (14).
Always connect the USB storage device directly to the radio and never use a USB
press the play / pause button (15, 25) during playback to pause
press the next button (11, 34) during playback to skip to the next
press the previous button (11, 34) during playback to skip to
when the repeat function is enabled, the current track, a
15