Safety Instructions For Installation - Miele KM 6113 Operating And Installation Manual

Safety instructions for installation

The appliance must only be installed
and connected to the electricity
supply by a suitably qualified and
competent person in strict
accordance with current national
and local safety regulations.
Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the appliance.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
The hob may not be built in over a
fridge, fridge-freezer, freezer,
dishwasher, washing machine or
tumble dryer.
~
This hob must not be installed
above ovens or cookers unless these
have a built-in cooling down fan.
52
~
After installing the hob, ensure that
the connection cable cannot come into
contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
~
Observe carefully the safety
distances given on the following pages.
All dimensions in this instruction booklet
are given in mm.