Table of Contents
Advertisement
INSTALLATION AND CONNECTION
INSTRUCTIONS
Installing the Dishwasher
•
The dishwasher must be installed on a firm floor
and adjusted such that it is stable and level.
•
Using the spanner supplied, extend the threaded
feet to compensate for unevenness in the floor
and to adjust the height of the appliance to suit the
surrounding units. The rear feet of the unit are to
be adjusted with a screwdriver from the front of
the unit for built-in and integrated dishwashers.
•
The drain hose, inlet hose and mains cable must
be laid such that they are free to move in the rear
of the plinth recess, so that they cannot be kinked
or crushed.
•
The dishwasher must also be screwed on tightly to
the work surface or to the adjoining units. This is
absolutely necessary so that its stability is guaran-
teed according to VDE regulations.
Depending on type, the dishwasher is to be installed
as follows:
Dishwashers That Can Be
Integrated
(see installation template supplied)
3
The door of the appliance can be fitted with a
wooden/facing panel with the following
dimensions
Width:
Thickness:
Height:
(variable)
Weight:
If the facing panel is longer than 600 mm, the
1
door of the appliance cannot be opened
completely (the facing panel bumps against
the plinth).
If this is the case, the plinth must be cut out
(see installation template) or the brace
adapter for the extra long door BLT 60 must
be used. You can obtain this with the E No.
911 239 008.
591 – 594 mm
16 – 24 mm
dependent on
max. 8 kg
- Aperture height
- Plinth height
- The adjustment so that the unit matches the height
of the adjoining units
The exact height of the adjoining units must be
measured at the place of installation.
23
Advertisement
Table of Contents
