INSTALLATION AND CONNECTION
Installing the Dishwasher
The dishwasher must be installed on a firm floor
and adjusted to ensure that it is stable and level.
To compensate for unevenness in the floor and to
match the height of the appliance to that of sur-
rounding units extend the threaded feet by
– use a screwdriver.
For built-in, integrated and fully integrated dish-
washers, the rear feet should be adjusted from the
front of the appliance using a screwdriver.
The drain hose, inlet hose and mains cable must
not be kinked or crushed when the dishwasher is
The dishwasher must also be screwed on tightly to
the work surface or to the adjoining units. This is
essential to ensure the diswasher does not tip.
Depending on type, the dishwasher is to be installed as follows:
Dishwashers That Can Be Inte-
(see installation template supplied)
The door of the appliance can be fitted with a
wooden furniture door with the following
591 – 594 mm
16 – 24 mm
max. 8 kg
- Recess height
- Plinth height
- The adjustment so that the unit matches the height
of the adjoining units
The exact height of the adjoining units must be
measured at the place of installation.