Serial Ata Raid For Silicon Image 3112A - AOpen AX4SG MAX Manual

A X 4 S G M a x
A X 4 S G M a x
S e r i a l A T A R A I D
S e r i a l A T A R A I D
TM
Silicon Image's SATARaid provides Serial ATA Software RAID including Striping and Mirroring to enhance the industry's first proven
PCI-to-SATA host controller product.
Standard with SATARaid software is a Graphical User Interface (GUI) that provides easy-to-use configurations for the different RAID
Sets supported.
I n s t a l l i n g D r i v e r s a
I n s t a l l i n g D r i v e r s a
The driver is located on the provided floppy disk. Insert the floppy disk into the floppy disk drive and click Browse. Most floppy disk
drives are configured as [A:]. Choose the [A:] drive in your browser and the Si3112r.inf file for the SiI 3112. Select the file and click
Open.
For Windows NT system, please select the file Oemsetup.inf and click Open. The next window allows you to select which driver to install.
Select SiI 3112 Raid Controller and click on OK.
For Windows 98/ME, please use the driver installation files (siI3112r.sys) on the provided floppy disk if necessary.
Now, a window verifying that the new Driver for the board has been properly installed. Click Finish.
It is always good to restart the computer after an installation. When asked to do so, click yes.
To install SATARaid, use Windows InstallShield by performing the following:
1. After computer restarts, insert CD in disk drive.
2. Double-click on Install SATARaid.exe.
3. Follow on-screen instructions to complete installation.
Note: Do NOT install in the Start Up folder. Choose the Default folder (normally Accessories or Administrative Tools or something
similar).
f o r S i l i c o n I m a g
f o r S i l i c o n I m a g
n d S A T A R a i d G U I i
n d S A T A R a i d G U I i
e 3 1 1 2 A
e 3 1 1 2 A
n W i n d o w s 9 8 S E / M
n W i n d o w s 9 8 S E / M
89
O n l i n e
O n l i n e
E / 2 0 0 0 / N T / X P
E / 2 0 0 0 / N T / X P
M a n u a l
M a n u a l