AOpen AX4SG MAX Manual page 126

A X 4 S G M a x
A X 4 S G M a x
I n s t a l l i n g S i l i c o n
I n s t a l l i n g S i l i c o n
---------------------------------------------------------------------------------
1) Windows NT 4.0 and Windows 2000/XP Fresh Installation
---------------------------------------------------------------------------------
Follow the instructions in this section if you are performing a new installation of Windows NT 4.0 or Windows 2000/XP, and you wish to boot
from a device attached to the SiI 3112 controller.
1. Power off the system. Connect the hard drives to the SiI 3112 controller and insert the controller into a PCI slot. Power up the system.
2. Put your Windows NT/2000/XP CD into the CD-ROM/DVD drive, or the NT/2000/XP boot diskette #1 in the floppy drive if your system
cannot boot from the CD.
3. Press F6 for third party SCSI or driver installation at the beginning of text mode installation. Press's' when setup asks if you want to
specify an additional device, and insert the diskette labeled 'Silicon Image SiI 3112 SATA Raid Driver Installation Disk' . Press 'Enter' and
select 'Silicon Image SiI 3112 SATA Raid Controller'
4. Press 'Enter' to continue on with text mode setup.
5. Follow the setup instructions to select your choice for partition and file system.
6. After setup examines your disks, it will copy files to Windows 2000 installation folders and restart the system. The setup program will
continue and finish the installation after Restart.
7. Wait until Windows 2000 finishes installing devices, regional settings, networking settings, components, and final set of tasks, reboot the
system if it is required.
8. See instructions in section 4 to verify controller was installed correctly.
I m a g e S i I 3 1 1 2 A S
I m a g e S i I 3 1 1 2 A
A T A R a i d D r i v e
S A T A R a i d D r i v e
126
O n l i n e M
O n l i n e M
r
r
a n u a l
a n u a l