Table of Contents
Advertisement
Image SiI 3114 controller card, you need to run the update program to install
Silicon Image driver. The driver package is located in the Silicon Image driver
diskette or the diskette provided by OEM vendor.
1. Power off the system. Connect the hard drives to the SiI 3114 controller and
insert the controller into a PCI slot. Power up the system.
2. During the system boot up, the Hardware Wizard will display that it found a '
PCI RAID Controller', click ' Next'. Select ' Search for the best driver for your
device [Recommended]' and click ' Next'.
3. Check the ' Floppy disk drives' and insert the driver diskette into floppy drive.
Click ' Next'.
4. System will go through the enumeration process and install the driver. At the
end of the process, click ' finish' to complete the installation. Reboot the
system if your Windows 98SE/ME drive is connected on the SiI RAID
Controller.
5. See instructions in section 4 to verify controller was installed correctly.
9) Update SiI RAID driver on Windows 98SE/ME with existing Silicon Image driver
With the Silicon Image controller already plugged in and the driver already
installed. Follow the instructions to update SiI 3114 driver.
1. Right click on 'My Computer' and select 'Properties'. Under 'System
Properties', click 'SCSI and RAID Controller' and right click 'Silicon Image
Ultra-133 Medley ATA Raid Controller'.
2. Click 'Driver','Update Driver' and select 'Automatic search for a better driver
[Recommended]'. Insert the driver diskette into floppy drive. Click 'Next' and
complete the driver installation.
3. System will go through the enumeration process and install the driver. At
the end of the process, click 'Yes' to reboot your system.
4. See instructions in section 4 to verify controller was installed correctly.
57
Advertisement
Table of Contents
