Table of Contents
Advertisement
3.4 Jumper Settings
JP2 Speaker Output
(only for n250a-FR)
1
Buzzer
(default)
JP14 Clear CMOS Data
Allows you to turn off the voice from buzzer or
speaker. You can choose not to be bothered by
the warning made from Dr. Voice when it detects
any error in operating system.
JP2 Speaker Output Jumper
1
Speaker
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
JP14 Clear CMOS Jumper
1
Normal
(default)
33
1
Clear CMOS
Advertisement
Table of Contents
