AOpen n250a-FR Manual page 55

1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware'
tab, and then on 'Device Manager' button.
2. Double click on 'SCSI and RAID Controllers', If there is no yellow '! 'or '? ' in
front of 'Silicon Image SiI 3114 SATARaid Controller', the driver is started
correctly.
3. To view information about the devices attached to the controller, use the
SiICfg Utility and click on the device from the list.
For Windows NT 4.0
1. Double click on 'My Computer' icon, select 'Control Panel', click on 'SCSI
Adapters' icon, 'Silicon Image SiI 3114 SATARaid Controller' should displayed
correctly under 'Device' and 'Driver' tab.
2. To view information about the devices attached to the controller, use the
SiICfg Utility and click on the device from the list.
5) Update SiI RAID driver on Windows NT 4.0 with existing Silicon Image driver
1. After OS boots up, Click 'Start'.
2. Under 'Settings', click 'Control Panel'.
3. Select 'SCSI Adapters' from the Control Panel.
4. Select the 'Drivers' tab and click 'Add'.
5. Click 'Have Disk'.
6. Insert the diskette labeled 'Silicon Image SiI 3114 SATARaid Driver
Installation Disk' into A: and press 'Enter'.
7. Choose 'Silicon Image SiI 3114 SATARaid Controller' and click 'OK'.
8. Refer to instructions in section 4 to verify controller was installed correctly.
6) Update SiI RAID driver on Windows 2000/XP with existing Silicon Image driver
With the Silicon Image controller already plugged in and the driver already
installed. Follow the instructions to update SiI RAID driver.
1. Right click on 'My Computer' and select 'Properties'. Under the 'System
Properties' section, click on 'Hardware' tab, and then on 'Device Manager'
click 'SCSI and RAID Controller' and right click 'Silicon Image Ultra-133
Medley ATA Raid Controller'.
2. Click 'Driver','Update Driver' and select 'Search for a suitable driver for my
55