Table of Contents
Advertisement
Remove 2 screws •, then pull door • as per arrowhead direction and you will remove the door.
Please remove bottom hinge (Right) • as well for the assembly. (Fig.A & Fig.B)
Remove 3 screws• of right upper Hinge, then remove right upper•& Right lower hinges•; (See
fig.C)
Use the screws which you removed From right side hinges to fix left upper & bottom hinges••
(See Fig.D & Fig.E)
Rotate door at 180 degrees then assemble the door as per the reverse way of removal
Fitting a kitchen plinth
These models are recessed to fit a kitchen plinth. A H50mm vent slot is required in the plinth to ensure air is
able to ventilate correctly.
DEFROSTING/CONDENSATION
Your wine cabinet is designed with an "Auto-cycle" defrost system. When the RUN cycle is OFF, the
refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The defrost water
is channeled into a drain pan which is located at the back of the wine cabinet next to the
compressor from where it evaporates.（注意修改）
HUMIDITY MAINTENANCE SYSTEM
The wine cabinet is equipped with a system for maintaining the correct level of humidity. If humidity
See diagram below.
Failure to include this vent slot will invalidate the guarantee.
490mm
5
Advertisement
Table of Contents
