Messages And How To React To Them - Pioneer AVIC-900DVD Operation Manual

Dvd navigation unit
Hide thumbs Also See for AVIC-900DVD:
Table of Contents

Advertisement

CRB1881A_ENGLISH.book Page 63 Thursday, April 24, 2003 11:54 AM
The Remote Control fails to work.
Possible causes:
(1) The batteries are low.
(2) The batteries have been inserted incorrectly.
(3) The Remote Control is pointing at the floor or
a seat.
(4) The signal receptor on the display is exposed
to direct sunlight.
Solutions:
(1) Change the batteries.
(2) Check that the batteries are properly inserted
according to the + and – markings.
(3) Ensure that the Remote Control has a clear
line of sight to the display unit.
(4) Move the Remote Control closer to the
receiver on the display unit.
When the screen is frozen...
Park your vehicle at a safe place, and cut the
engine off. Turn the ignition key back to "Acc
off". Then start the engine again, and turn the
power to the main unit back on. If this does
not solve the problem, press the reset button
on the main unit.
Messages and How to React to
Them
The following messages may be displayed by your
Navigation System.
There are occasions when you may see error
messages other than those shown here. In
such a case, follow the instructions given on
the display.
(1) "You cannot use this function while
driving."
When:
While trying to make a menu selection.
What to do:
Pull over and come safely to a halt, put the hand-
brake on, and then try again.
(2) "This is not the appropriate disc.
Please insert the appropriate disc."
When:
(1) If you try to use a disc which is incompatible
with this system (including the old version
map disc).
(2) If you insert a disc upside down.
(3) If the disc is dirty.
(4) If the disc is cracked or otherwise damaged.
What to do:
(1) Insert a suitable disc.
(2) Insert the disc with the label upward.
(3) Clean the disc.
(4) Insert a normal, round disc.
(3) "Irregular speed pulse signal is
detected. Please turn system power
off and check the installation. After
checking, please re-boot the system
and press "OK"."
When:
If the Navigation unit does not receive the vehicle
speed pulse.
What to do:
Consult your Pioneer dealer.
63

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avic-800dvd

Table of Contents