Operating Your Navigation System With Voice; Basics Of Voice Operation; Flow Of Voice Operation; Operating By Only Voice When The Navigation System Is Started - Pioneer AVIC-900DVD Operation Manual

CRB1881A_ENGLISH.book Page 51 Thursday, April 24, 2003 11:54 AM

Operating Your Navigation System with Voice

Basics of Voice Operation

Your Pioneer Navigation System comes with the
latest in voice recognition technology. You can
use voice commands to operate many of its func-
tions. This chapter describes where you can use
voice commands, and also what commands the
system accepts.

Flow of voice operation

You can start voice operation any time even when
the map screen is displayed or audio is operated.
The basic steps of voice operation are as follows.
The steps are almost the same as when using the
Remote Control.
1
Press the TALK (or VOICE) button to
activate voice operation.
2
Speak a command into the micro-
phone.
3
When the command is recognised, it is
repeated.
4
As necessary, repeat Steps 2 and 3.
5
The voice command is carried out.
❒
With the "CD-SR80" Steering Remote Control
(sold separately), you can press the BAND
button and the F button to switch on the oper-
ation mode of the Steering Remote Control.
When the operation mode is switched on, by
pressing the BAND button of the Steering
Remote Control, you can activate voice opera-
tion, which is equivalent of pressing the TALK
button. ("CD-SR90" and "CD-SR100" can be
used. For the details of their operation, see the
instruction manuals attached to them.)
Operating by only voice when
the Navigation System is
started
Turning on "Auto Voice Recognition" in the
Settings menu allows all settings to be imple-
mented by voice from after the engine is started
and until the route is set (applies only if the route
is not yet set).
❒
If you press the button on the Remote Control
in the middle of the operation, voice operation
mode is cancelled.
Available voice commands
related to Navigation
You can say the following commands:
Common commands for all the opera-
tions
Next Page, Previous Page, Back, Next Option,
Repeat
❒
If you want to listen to the message of the
Navigation System, say "Repeat".
❒
If you want to return to the previous screen,
say "Back".
❒
If the system fails to recognise the command
you speak, press the TALK button or VOICE
button or say "Next option" and other operable
commands will be displayed. If you then press
the TALK button or VOICE button within 3
seconds, yet more commands are shown.
Repeat this until the command you want to
use is shown.
5
Chapter
51