Electrolux ESF 66860 User Manual page 13

Malfunction
The appliance does not
fill with water.
The appliance does not
drain the water.
The anti-flood device
operates.
The programme does
not start.
After the check, switch on the appliance. The
programme continues from the point of in-
terruption.
If the malfunction shows again, contact the
service centre.
If the display shows other fault codes, con-
tact the service centre.
The necessary data for the service centre is
on the rating plate.
Fault code
The display shows
The display shows
The display shows
Possible cause
The water tap is
blocked or is furred with
limescale.
The water pressure is
too low.
The water tap is closed. Open the water tap.
The filter in the water in-
let hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is not
correct.
The water drain hose is
damaged.
The appliance door is
open.
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
The delay start is set.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
electrolux 13
Possible solution
Clean the water tap.
Contact your local wa-
ter authority.
Clean the filter.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter inlet hose has no
damages.
Clean the sink spigot.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter drain hose has no
damages.
Close the water tap and
contact the service
centre.
Close the door correct-
ly.
Put in the mains plug.
Replace the fuse.
If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
....................
....................
....................