Select And Start A Washing Programme - Electrolux ESF65710 User Manual

comes on, indicating that the rinse aid
dispenser has been activated.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
6. To deactivate the rinse aid dispenser
again, follow the above instructions until
the End indicator light goes off.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (refer to 'Washing
programmes' chart).
When a programme has been selected
the corresponding light comes on.
The digital display shows 3 horizontal
bars.
The programme in progress indicator
light comes on.
Close the dishwasher door, the pro-
gramme starts automatically.
The programme in progress indicator
light remains on.
The digital display shows only 1 horizon-
tal bar and will remain on for all the dura-
tion of the washing programme.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the digital display shows the flashing
number of hours for the delay start. The
start of the selected washing programme
can be delayed for between 1 and 9
hours.
1. Deactivate the Multi-tab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
2. Close the dishwasher door, the count-
down starts automatically. The number in
the display is no longer flashing but fixed
with static light.
3. The countdown will decrease in steps of
1 hour.
4. Opening the door will interrupt the count-
down. Close the door; the countdown will
continue from the point at which it was
interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
With the delay start function set, the
programme in progress indicator light
is off. Once the countdown of the delay
start has elapsed, the washing pro-
gramme will start automatically and the
programme in progress indicator light
will come on.
The selection of the washing pro-
gramme and delay start can occur also
with the door closed.
When you press a programme button
you have ONLY 3 seconds to select a
different programme or a delay start.
After these 3 seconds, the selected pro-
gramme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
electrolux 15