Thick Stock - Konica Minolta bizhub C35 User Manual

Keep media between 15% and 85% relative humidity. Toner does
not adhere well to moist or wet media.
Layered
Adhesive
Folded, creased, curled, embossed, warped, or wrinkled
Perforated, three-hole punched, or torn
Too slick, too coarse, or too textured
Different in texture (roughness) on the front and back
Too thin or too thick
Stuck together with static electricity
Composed of foil or gilt; too luminous
Heat sensitive or cannot withstand the fusing temperature (180°C
[356°F])
Irregularly shaped (not rectangular or not cut at right angles)
Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
Acidic
Any other media that is not approved

Thick Stock

Paper thicker than 90 g/m
You can print continuously with thick stock. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Capacity
Orientation Tray 1
Driver
Media Type
Weight
Duplexing
Print Media
2
(24 lb bond) is referred to as thick stock.
Tray 1/2 Up to 20 sheets, depending on their thick-
ness
Tray 3/4 Not supported
Face down
Tray 2 Face up
Thick 1 (91–150 g/m²)
Thick 2 (151–210 g/m²)
91 to 210 g/m²
Refer to "Specifications" on page 4-2.
4-5