Table of Contents
Advertisement
Error Messages on the Message Window
Error message
LINE PROBLEM
(Flashing alter-
nately)
CHECK LINE
*COMM.ERROR*
(####)
*REDIAL ALL FAILED* All redial attempts failed
*MEM.FULL/TX CAN-
CEL*
*MEM.FULL/RX CAN-
CEL*
HANG UP THE
PHONE
Error Messages on the Message Window
EDNord - Istedgade 37A - 9000 Aalborg - telefon 9633 3500
Cause
The telephone dialing
system or telephone
wiring system is not
set correctly.
The telephone cable
is not attached cor-
rectly.
Communication is not
possible because of
some problem in the
machine.
Communication is not
possible because of a
problem with the
recipient/caller's fax
machine.
because either the recip-
ient's line is busy or
there was no answer.
While sending a fax, the
size of the data for the
scanned image has
exceeded the capacity of
the memory.
While receiving a fax,
the size of the data for
the scanned image has
exceeded the capacity of
the memory.
The receiver of the con-
nected telephone is
lifted.
Solution
Check the telephone dialing
system or telephone wiring
system and use the appropri-
ate configuration menu to
make the correct settings.
Correctly connect the tele-
phone cable.
Check the transmission results.
Check the condition of the recipi-
ent's line, and then try sending
the fax again.
Retrieve all received faxes stored
in the memory.
Send the fax by direct transmis-
sion.
To print an error report, press the
Cancel/C key while an error
message is displayed.
Retrieve all received faxes stored
in the memory.
To print an error report, press the
Cancel/C key while an error
message is displayed.
Replace the receiver of the con-
nected telephone on the hook.
69
Advertisement
Table of Contents
