Nokia 32 User Manual page 13

4 Connect the power cord from the power
supply to the Nokia 32 terminal.
5 Connect the power supply to an AC wall
outlet. When the Nokia 32 terminal is
powered up, it shows the GSM signal
strength with light indicators. Make sure
that the signal strength is adequate to
make and receive calls, see "Light indicators" on page 25.
Note: Use only the ACW-5 power supply provided with the Nokia 32
terminal. The use of any other power supply may cause damage to the
terminal.
6 Use the telephone connected to the Nokia 32 terminal to enter the PIN code,
if your SIM card requires it: when light indicator 2 blinks red, lift the receiver.
When you hear the enter PIN code tone, enter the PIN code followed by #. The
Nokia 32 terminal gives the OK tone, and light indicator 1 lights up.
Note: If entering the PIN code fails, see "Entering PIN code does not
succeed" on page 39. If the AutoPIN feature is active, the Nokia 32
terminal automatically enters your PIN code the next time the power is
switched on.
7 Make a test call using the telephone connected to the Nokia 32 terminal.
To adjust the volume, key in 0**x during the call. Replace x with a value ranging
from 1 (the lowest volume level) to 10 (the highest volume level).
©
Copyright 2003 Nokia. All rights reserved.
13