Nokia 32 User Manual page 19

Setting up the busy tone monitoring
When the Nokia 32 terminal is used in the extension mode with a PBX, the busy
tone must be monitored on the PBX. Tone monitoring is needed because the PBX
emits the tone when the hook-on transition occurs in the extension line.
The Tone Teaching feature of the Nokia 32 terminal is used to teach the Nokia 32
terminal the busy tone of each PBX.
After the Nokia 32 terminal has physically been installed to the final position, the
learning mode can be activated:
1 Make a call from another extension to the extension where the Nokia 32
terminal is installed.
2 After you get the dial tone from the Nokia 32 terminal, dial
**####**1234#88**own_ext_number#
(own_ext_number is the extension number where you are commanding the
Nokia 32 terminal from).
3 After the last digit (#), put the receiver down, and wait until the
Nokia 32 terminal calls you back.
4 When the phone in the extension rings, pick up the receiver, and
listen to the tone:
• If you hear a busy tone, the learning did not succeed, and you should repeat
the steps.
• If you hear three beeps, the Nokia 32 terminal has learned the busy tone.
©
Copyright 2003 Nokia. All rights reserved.
19