Attaching The Air Purifying Filters - Hitachi RAS-V10CDT Installation Manual

ATTACHING THE AIR PURIFYING FILTERS

CAUTION
!
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
1
Open the front panel
Pull up the front panel by holding it at both sides with
●
both hands.
2
Remove the Pre-fi lter
Push upward to release the claws and pull out the
●
Pre-fi lter.
3
Attaching the air purifying fi lters
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion
into Pre-fi lter frame.
!
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
4
Attach the Pre-fi lters
Attach the Pre-fi lters by ensuring that the surface
●
written "FRONT" is facing front.
After attaching the Pre-fi lters, push the front panel at
●
three arrow portions as shown in fi gure and close it.
NOTE
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
●
purifying fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
Air purifying fi lters are not washable. It is recommended to use vacuum to clean it. It can be use
●
for 1 year time. Type number for this air purifying fi lter is <SPX-CFH22>. Please use this number
for ordering when you want to renew it.
RAS-V10CDT-V13CDT (EN2) 17 RAS-V10CDT-V13CDT (EN2) 17
CAUTION
– 17 –
1/4/14 10:32 AM 1/4/14 10:32 AM