Hitachi RAS-V10CDT Installation Manual page 19

2. CLEANING OF FRONT PANEL
● Remove the front panel and wash with clean water.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with
clean water.
When front panel is not removed, wipe it with a
●
soft dry cloth. Wipe the remote controller thoroughly
with a soft dry cloth.
Wipe the water thoroughly.
●
If water remains at indicators or signal receiver of
indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to
detach and attach it.
Removing the Front Panel
● When the front panel is fully opened with both
hands, push the right arm to the inside to
release it, and while closing the front panel
slightly, pull it out forward.
! CAUTION
Never use hot water (above 40°C), benzine, gasoline, acid, thinner
●
or a brush, because they will damage the plastic surface and the
coating.
RAS-V10CDT-V13CDT (EN2) 19 RAS-V10CDT-V13CDT (EN2) 19
Attaching the Front Panel
● Move the projections of the left and right
arms into the Flanges in the unit and securely
insert them into the holes.
– 19 –
1/4/14 10:32 AM 1/4/14 10:32 AM