Table of Contents
Advertisement
dedicated line output.
Fader, the signal you selected is then routed through the Pan Pot so you as the
operator can pan it hard Left (Channel 1 output), hard Right (Channel 2 output)
or anywhere in between. This is useful for music recordings and also for stereo
mixdowns for dailies. Normally, you would use main outputs 1 and 2 as a stereo
pair for dailies.
Channels 3 to 8:
Channels 3 through 8 are handled in a similar way. They also incorporate the 3-
way toggle switch allowing your choice of Pre-Fader, Off or Post-Fader audio
feeds.
They are somewhat simplified in that they do not have any panning
function built into them. Main outputs 3 through 8 can be used for 3 stereo pairs
to feed 3 cameras, or for multi-track recording or for combinations of these two.
Channel Fader
The Solice mixer is equipped with Penny and Giles conductive plastic faders.
These faders have proven themselves over the years as the best possible fader
for professional portable mixer use.
and are generally noise free.
control range at your finger tips.
lines
every
10dB
Recommended normal operating range is at the "0" line. This will leave you with
an additional 10dB of signal range if needed for those hard to mic actors.
Pre-Fade Listen Switch
Each input channel of the Solice mixer is equipped with a Pre-Fader Listen
switch.
These momentary contact, red pushbutton switches are located at the
bottom of each input channel.
individual input channel is routed directly to the Mixer's headphones.
mixer can quickly and easily monitor individual microphones (or wireless) without
having to open the channel fader (pot up that channel) This allows the mixer to
check on the audio quality and level of any individual microphone even while
recording using other inputs.
Dedicated Line Outputs
Each of the eight input channels is equipped with a dedicated, balanced line
output on a ¼" stereo connector.
fact, it uses the same circuitry as the main XLR balanced outputs.
dedicated line outputs can drive up to a +20dBm signal for maximum headroom.
Input channel signals are routed to the dedicated line output via the "Line Out"
toggle switch and line out rotary level pot. The toggle switch has three positions.
Switched to the Left, it feeds the dedicated line output with Pre-fader audio.
However, once you have selected Pre-Fader or Post-
These faders offer silky smooth operation
The channel faders offer more than 70dB of
The mixer overlays are labeled with coarse
under
the
fader
When pressed, pre-fader audio from that
This balanced output is very high quality; in
knobs
for
operator
convenience.
Thus the
These
12
Advertisement
Table of Contents
