Restoring Factory Settings; Lsr4300 Control Center Software - JBL LSR4312SP Owner's Manual

Restoring Factory Settings

Setting the rear-panel Sub1 and Sub2 ID DIP Switches to the ON (right) position and re-powering the
LSR4312SP clears all user settings (such as RMC calibration and bass management and fi lter settings)
stored in the speaker's memory.
To clear the memory of a speaker and recall the factory settings:
1. Turn the LSR4312SP subwoofer off and disconnect its power cable.
2. Set the Sub1 and Sub2 DIP switches to the ON position.
3. Re-connect the power cable, wait for the JBL logo to dim, then turn the LSR4312SP back on. All front
panel controls will blink and the LED display will fl ash a left-right pattern to show that memory settings are
being recalled.
4. Reset all DIP switches to the desired positions for network operation.
X
User settings such as RMC remain stored in each speaker, even when powered down. For that reason, if you
are using an LSR4300 system that you did not personally set, it's a good idea to restore factory settings before
using it.
Note: After restoring factory settings, the RMC button in all speakers and subwoofers will light steadily red, indicating
that there is no RMC data in memory and that a new RMC calibration needs to be carried out.

LSR4300 Control Center Software

The LSR4300 Control Center Software supplied with the LSR4300 Accessory Kit allows you to control all
front panel LSR4312SP functions using a connected Windows or Macintosh computer.
In addition, the onscreen display shows RMC settings in the LSR4312SP as well as polarity and digital
input channel selection and assignment (i.e., Bass Management / LFE DIP switch setting).
Other functions allow you to DIM or MUTE the entire system and store and recall entire system
confi gurations.
X
Whenever you DIM the system with the use of either the wireless remote control or LSR4300 Control
Center Software, the JBL logo on all networked speakers and subwoofers will blink until the DIM button
is pressed a second time, restoring the system volume to its original level.
For more information about the use of this software, refer to the LSR4300 Control Center Software User
Guide, provided on disk with the LSR4300 Accessory Kit. Version 2.0 or later software is required for use
with the LSR4312SP subwoofer. The latest version of the software and documentation are also available
for downloading at www.jblpro.com.
X
LSR4300 Control Center Software cannot work with an LSR4312SP subwoofer on its own; it only
works in a networked system of one or more LSR4328P or LSR4326P studio monitors, with the com-
puter connected via USB to the LSR4328P or LSR4326P speaker designated as the LEFT speaker.
Reference - Restoring Factory Settings
LSR4300 Control Center Software
33