JBL LSR4312SP Owner's Manual page 29

the Bass Management Crossover frequency selection.
3. Sub LEVEL settings - In conjunction with the +/- button increases or decreases the subwoofer level
inde pendent of the rest of the system.
4. SUB1 and SUB2 soloing, as well as LFE solo - Mutes all other speakers in the system. Also, in
conjunction with Bass Management ON/OFF button, allows isolation of the LFE signal.
5. LFE Low Pass Filter Frequency - In conjunction with the +/- button allows selection of the LFE Low
Pass Filter setting.
X
Note: Buttons on the earlier versions of the LSR4300 Remote Control are labeled differently such that the
function BASS MGMT ON is labeled BM OFF and the function LFE FILTER is labeled LFE. Both versions of the
remote control are compatible with the LSR4312SP Subwoofer. Only the labels are different.
X
The remote control cannot work with an LSR4312SP subwoofer on its own; it only works in a networked
system of one or more LSR4328P or LSR4326P studio monitors, and must always be aimed at the speaker
designated as the LEFT speaker.
X
The remote control cannot be used to initiate the RMC calibration process.
To turn Bass Management on or off, press the Bass Mgmt ON button in the "sub" section of the remote.
To adjust the Bass Management X OVER or LFE FILTER settings, with the remote control, press the
corresponding button in the "sub" section of the remote, and then use the remote control (+/-) button to
make the selection. The corresponding front panel LSR4312SP button will begin blinking and the meter
display will update accordingly.
To SOLO the LSR4312SP designated as "SUB 1" (DIP switch 1 set ON), press the SUB1 button in the
"Solo" section of the remote.
To SOLO the LSR4312SP designated as "SUB 2" (DIP switch 2 set ON), press the SUB2 button in the
"Solo" section.
To SOLO the LFE signal, turn "Bass Management" OFF by pressing the remote control BASS
MANAGEMENT "ON" Button, and press the "SOLO" button for Sub 1 and/or Sub 2.
X
Whenever you DIM the system with the use of either the wireless remote control or LSR4300 Control Center
Software, the JBL logo on all networked speakers and subwoofers will blink until the DIM button is pressed a
second time, restoring the system volume to its original level.
Note: The EQ ON, HF, LF and PRESET remote control functions are functional only in LSR4328P and
LSR4326P studio monitors and do not affect settings in the LSR4312SP subwoofer.
Reference - Remote Control
23