Getting Connected; Attaching Your Battery; Charging Your New Battery - Nokia 6185 Owner's Manual

Accessories and Batteries
Use only approved accessories and batteries. Do not
connect incompatible products.
FCC/Industry Canada Notice
Your phone may cause TV or radio interference (e.g. when using a
telephone in close proximity to receiving equipment). The FCC/
Industry Canada can require you to stop using your telephone if
such interference can not be eliminated. If you require assistance,
contact your local service facility.
This device complies with part 15 of the FCC rules. Operation is
subject to the condition that this device does not cause harmful
interference.
Using this Guide
The wireless phone described in this guide is approved for use in
CDMA/AMPS networks.
A number of features included in this guide are called Network
Services. They are special services provided by wireless service
providers. Before you can take advantage of any of these Network
Services, you must subscribe to the service(s) from your home
service provider and obtain instructions for their use.
Disclaimer
It' s possible that you may not be able to activate your phone on
all wireless systems. Please see your service provider for details.
2

2. Getting Connected

This section will help you understand the ins and outs of
charging and using your battery.

Attaching your battery

Simply place the battery
in the grooves on the
back of your phone. Then
slide the battery upward
until it clicks.
Note: Use only those
batteries approved by the
phone manufacturer and
recharge your battery only
with the chargers approved
by the manufacturer.
See "Important Battery Information" on page 6.

Charging your new battery

Your phone can be used with either a rechargeable Li-Ion
or NiMH battery. Note that a new battery' s full
performance is achieved only after two or three complete
charge and discharge cycles.
With your phone powered
on or off, connect the lead
from the charger to the
bottom of your phone.
You can also place your
phone on the charging
stand (with the stand
connected to a standard
120V AC outlet via either the ACP-7U or ACP-9U AC/DC
adaptors).
When the battery begins charging, your phone will beep
once and the battery strength indicator on the right side
of the display will begin to scroll after a few seconds.
3