Changing The Language; Meaning Of Messages And What To Do; Resetting Factory Default Settings; Washing - DeLonghi Coffee Maker Manual

• Press the button repeatedly until the number coincides with the number of red squares on the
test strip (for example, if there are 3 red squares on the test strip, press the button until WATER HARD-
NESS 3 is displayed).
• Press the button to confirm the value. The coffee maker is now programmed to provide the desca-
ling warning when necessary, based on the actual hardness of the water.

12.7 Resetting factory default settings

If you change the original values, the factory default values can be reset as follows:
• Press the button then press the
• Press the button and the appliance displays "RESET TO DEFAULT YES";
• Press the button to reset the factory default values;
• Press the button to exit programming mode or

12.8 Washing

This function can be used by technical service personnel only.

13 CHANGING THE LANGUAGE

To change the language, proceed as follows:
• Press the button for at least 5 seconds until the appliance displays:
and press the button for at least 3 seconds to confirm. The appliance then displays the setting mes-
sage in English.

14 MEANING OF MESSAGES AND WHAT TO DO

MESSAGE
FILL TANK
GROUND TOO FINE
ADJUST grinder AND
open STEAM
EMPTY used coffee
CONTAINER
INSERT used coffee
button repeatedly until the appliance displays:
RESET TO DEFAULT NO
PRESS OK TO select ENGLISH
MEANING
• The water tank is empty or is positioned
incorrectly.
• The tank is dirty or encrusted with lime
scale.
• The appliance cannot make coffee
• The coffee runs off too slowly.
• The grounds container is full or missing. •
• After cleaning, the grounds container
has not been replaced.
to change other parameters
WHAT TO DO
• Fill the water tank as described in chap-
ter 5, note 6 and insert it fully.
• Rinse or descale the tank.
• Turn the steam knob counter-clockwise
(fig. 3) as described in chapter 5 note
10.
• Turn the grinding regulator (fig. 15) one
click clockwise (see chapter 7).
Empty the grounds container and clean
as described in chapter 5, note 7, then
replace.
• Open the service door and insert the
grounds container.
19