Page 1
MACCHINA DA CAFFÈ COFFEE MAKER MACHINE À CAFÉ KAFFEE-/ESPRESSO-VOLLAUTOMAT KOFFIEZETAPPARAAT CAFETERA MÁQUINA DE CAFÉ KÁVOVAR Istruzioni per l’uso Instructions Mode d’emploi Bedienungsanleitung Gebruiksaanwijzingen Instrucciones para el uso Instruções de utilização Návod k pouÏití...
Page 2
ELECTRICAL CONNECTION (UK ONLY) If your appliance comes fitted with a plug, it will incorporate a If the plug is a moulded-on type, the fuse cover must be re-fit- 13 Amp fuse. If it does not fit your socket, the plug should be cut ted when changing the fuse using a 13 Amp Asta approved off from the mains lead, and an appropriate plug fitted, as fuse to BS 1362.
1 DESCRIPTION OF THE APPLIANCE (SEE PAGE 3) A. Grinding coarseness regulator Control Panel B. Coffee beans container 1. Display C. Bean container lid 2. MENU light. D. Central lid for ground coffee 3. Button to activate or deactivate menu parame- E.
• After positioning the appliance on the work top, leave a space of at least 5 cm between the surfaces of the appliance and the side and rear walls and at least 20 cm above the coffee maker. • Never install the appliance in environments where the temperature may reach 0 or lower (the appliance may be damaged if the water freezes).
5. The appliance displays: TURNING OFF PLEASE WAIT and it goes off. 6. Fill the container with coffee beans (fig. 5). IMPORTANT: to prevent malfunction, never fill with ground coffee, freeze dried coffee, caramelised beans or anything else which could damage the appliance. 5 TURNING ON AND PREHEATING 1.
Page 10
NOTE 2: If the coffee is delivered too fast and is not creamy enough, turn the grinding coarseness regulator (fig. 12) one click anticlockwise (see section 8). Avoid turning the grinding coarseness regulator excessively otherwise when you select 2 cups, the coffee may run out in drips.
When using the appliance for the first time, 4-5 cups of coffee need to be made before the applian- ce starts to give satisfying results. If the appliance malfunctions, do not contact the service centre straight away. The problem can almost always be resolved by following the instructions indicated in paragraphs 18 and 19. If this is not the case, or for further explanations, contact the customer service by calling the number listed on the sheet enclosed on page pag.2.
9 PREPARING ESPRESSO COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS) • Press the button (fig. 16) to select the ground coffee function. This disables the coffee mill function. The appliance displays: READY PRE-GROUND • Lift the lid in the centre, place one measure of ground coffee in the funnel (see fig. 17) and proceed as described in section 6.
11 CHANGING THE QUANTITY OF HOT WATER The appliance is factory preset to automatically deliver 250 ml of hot water. To change these quantities, proceed as follows: • Attach the water spout (fig. 4). • Position a container under the spout (fig. 3). •...
Do not use solvents or abrasive cleaning products to clean the appliance. A soft damp cloth will suffice. NEVER wash ANY of the components of the appliance in a dishwasher. 15.1 Cleaning the coffee maker Clean the grounds container (as described in section 6, note 7) whenever it requires emptying.
To unblock them, scrape the dry coffee residues away with a needle (fig. 27). Clean the nozzle regularly with a sponge as shown in fig. 26. 15.2 Cleaning the infuser The infuser must be cleaned regularly to avoid the build-up of coffee encrustations which could cause mal- function.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from the mains, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door and replace the infuser.
Page 17
APPLIANCE IN DESCALE • the descale programme automatically performs a series of run offs and pauses to remove lime scale deposits from inside the coffee maker. • After about 30 minutes, the appliance displays: RINSING FILL TANK The appliance must now be rinsed through to eliminate residues of descaling solution from inside the applian- ce.
(for example, if there are 3 red squares on the test strip, press the button until WATER HARD- NESS 3 is displayed). • Press the button to confirm the value; The coffee maker is now programmed to provide the desca- ling warning when necessary, based on the actual hardness of the water.
16.7 Resetting factory default settings (reset) If you change the original values, the factory default values can be reset as follows: • Press the button then press repeatedly until the appliance displays: RESET TO DEFAULT NO • Press the button and the appliance displays "RESET TO DEFAULT YES: •...
Page 20
WHAT TO DO • After cleaning, the infuser has probably • Leave the service door closed and the been left out of the coffee maker. infuser out of the appliance, then follow PRESS NEXT CHANGE the instructions displayed. • The service door is open •...
Page 21
PROBLEM CAUSE SOLUTION When the • The ground coffee may be blocked in • Remove the ground coffee inside the funnel using a knife buttons are pressed, the the funnel. (see note 5, section 9). Then clean the infuser and the insi- de of the appliance (see description in section 11.2) appliance does not deliver coffee, but only water.
Need help?
Do you have a question about the Coffee Maker and is the answer not in the manual?
Questions and answers