Descaling - DeLonghi Coffee Maker Manual

Hide thumbs Also See for Coffee Maker:
Table of Contents

Advertisement

• Press the
button to set the auto-start time. (If you hold the
changed rapidly).
• Press the
button to confirm the value,
• Press
once and the appliance displays the message:
Press the
button to modify the function (the appliance displays AUTO-START YES");
• Press the
button to activate auto-start;
• Press the
button to exit programming mode or the

12.3 Descaling

Over time, the continuous heating up of the water used to make the coffee leads to lime scale building up in
the inner circuits of the appliance.
When the appliance displays the message:
you should perform the descale cycle.
Proceed as follows:
• make sure the appliance is ready.
• press the
button (the light over the button comes on) then press the
the appliance displays:
• Press
and the appliance displays the message:
• Press the
button to start the descale programme.
• Empty the tank and pour in the contents of one bottle (125 ml) of DURGOL descaler plus one liter of water.
For subsequent descaling operations, descaling solution can be purchased from authorised technical ser-
vice centres.
NB: Make sure splashes of descaler do not fall onto surfaces sensitive to acid such as marble, limestone
and glaze.
• Place a plastic or glass container with a minimum capacity of 50 oz under the hot water spout (Fig. 3);
• turn the steam knob half a turn counter-clockwise (fig.3). The descaling solution will run out of the cap-
puccino frother and start to fill the container underneath.
• the descale programme automatically performs a series of run offs and pauses to remove lime scale depo-
sits from inside the coffee maker.
• After about 30 minutes, the appliance displays:
• Turn the steam knob a half turn clockwise as far as it will go (fig. 4).
The appliance must now be rinsed through to eliminate residues of descaling solution from inside the applian-
ce. Proceed as follows:
• Remove the water tank, rinse and fill with clean water.
• Reposition the tank.
• Empty the collection container (under the cappuccino frother) full of liquid and then put it back under the
cappuccino frother.
• Turn the steam knob a half turn counter-clockwise (fig. 3).
AUTO-START NO
DESCALE
DESCALE NO
DESCALE YES
DESCALing COMPLETEd TURN KNOB
, button down, the time is
button to change other parameters.
button repeatedly until
17

Advertisement

Table of Contents
loading

Table of Contents