Warning Indications - JVC GR-DF425 Instructions Manual

Table of Contents

Advertisement

When the camcorder is connected via the
DV connector, the camcorder does not
operate.
The DV cable was plugged/unplugged with power
turned on.
HTurn the camcorder's power off and on again,
then operate it.
Images on the LCD monitor appear dark or
whitish.
In places subject to low temperature, images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
HAdjust the brightness and angle of the LCD
monitor. (
pg. 15, 17)
When the LCD monitor's fluorescent light reaches
the end of its service life, images on the LCD
monitor become dark.
HConsult your nearest JVC dealer.
Coloured bright spots appear all over the
LCD monitor or the viewfinder.
The LCD monitor and the viewfinder are made
with high-precision technology. However, black
spots or bright spots of light (red, green or blue)
may appear constantly on the LCD monitor or the
viewfinder. These spots are not recorded on the
tape. This is not due to any defect of the unit.
(Effective dots: more than 99.99%)
The cassette will not load properly.
The battery's charge is low.
HInstall a fully charged battery. (
Picture does not appear on the LCD
monitor.
The viewfinder is pulled out and "PRIORITY" is
set to "FINDER".
HPush the viewfinder back in or set "PRIORITY" to
"LCD". (
The LCD monitor's brightness setting is too dark.
HAdjust the brightness of the LCD monitor.
(
HIf the monitor is tilted upward 180 degrees, open
the monitor fully. (
An error indication (01 – 04 or 06) appears.
A malfunction of some kind has occurred. In this
case the camcorder's functions become
unusable.
H

Warning Indications

Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
Appears when no tape is loaded. (
pg. 12)
CHECK TAPE'S ERASE PROTECTION TAB
Appears when the erase protection tab is set to
"SAVE" while the Power Switch is set to "A" or
"M". (
TROUBLESHOOTING
pg. 17, 23, 26)
pg. 15)
pg. 17)
pg. 42.
pg. 14)
41
EN
Exhausted
pg. 16)

Advertisement

Table of Contents
loading

Table of Contents