Table of Contents
Advertisement
TROUBLESHOOTING
40
EN
Advanced features
The focus does not adjust automatically.
Focus is set to the Manual mode.
HSet Focus to the Auto mode. (
The lens is dirty or covered with condensation.
HClean the lens and check the focus again.
(
pg. 43)
In the 5-Second mode, recording ends
before 5 seconds have elapsed.
The 5-Second mode is set to "Anim." in MANUAL
Menu.
HSet "5S" to "5S" in MANUAL Menu.
(
pg. 23, 29)
Snapshot mode cannot be used.
The Squeeze mode (SQUEEZE) is selected.
HDisengage the Squeeze (SQUEEZE) mode.
(
pg. 23, 25)
The colour of Snapshot looks strange.
The light source or the subject does not include
white. Or there are various different light sources
behind the subject.
HFind a white subject and compose your shot so
that it also appears in the frame. (
The image taken using Snapshot is too
dark.
Shooting was performed under backlit conditions.
HPress BACK LIGHT. (
The image taken using Snapshot is too
bright.
The subject is too bright.
HSet "r" to "SPOTLIGHT". (
White Balance cannot be activated.
The Sepia (SEPIA) or Monotone (MONOTONE)
mode is activated.
HDisengage the Sepia (SEPIA) or Monotone
(MONOTONE) mode before setting White
Balance. (
pg. 35)
pg. 30)
pg. 30)
pg. 32)
pg. 35)
The Black & White Fader does not work.
The Sepia (SEPIA) or Monotone (MONOTONE)
mode is activated.
HDisengage the Sepia (SEPIA) and Monotone
(MONOTONE). (
The image looks like the shutter speed is
too slow.
When shooting in the dark, the unit becomes
highly sensitive to light when "GAIN UP" is set to
"AUTO".
HIf you want the lighting to look more natural, set
"GAIN UP" to "AGC" or "OFF". (
Other problems
The POWER/CHARGE lamp on the
camcorder does not light during charging.
Charging is difficult in places subject to extremely
high/low temperatures.
HTo protect the battery, it is recommended to
charge it in places with a temperature of 10°C to
35°C. (
pg. 44)
The battery pack is not attached firmly.
HDetach the battery pack once again and re-attach
it firmly. (
pg. 12)
"SET DATE/TIME!" appears.
The date/time is not set.
HSet the date/time. (
The built-in clock battery has run out and the
previously set date/time has been erased.
HConsult your nearest JVC dealer for replacement.
When the image is printed from the printer,
a black bar appears at the bottom of the
screen.
This is not a malfunction.
HBy recording with "DIS" activated (
this can be avoided.
pg. 35)
pg. 23, 24)
pg. 14)
pg. 23, 25)
Advertisement
Table of Contents
