Table of Contents
Advertisement
VIDEO PLAYBACK
22
EN
NOTES:
Set the video out select switch of the cable
adapter as required:
Y/C: When connecting to a TV or VCR which
accepts Y/C signals and uses an S-Video cable.
CVBS: When connecting to a TV or VCR which
does not accept Y/C signals and uses an audio/
video cable.
The S-Video cable is optional. Be sure to use
the YTU94146A S-Video cable. Consult the
JVC Service Center for details on its
availability. Make sure to connect the end with
a core filter to the camcorder. The core filter
reduces interference.
1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration.
If using a VCR, go to step 3.
If not, go to step 4.
3
Connect the VCR output to the TV input,
referring to your VCR's instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set
the TV to its VIDEO mode.
6
Start playback on the camcorder. (
To choose whether or not the following
displays appear on the connected TV
Date/time
Set "DATE/TIME" to "AUTO", "ON" or "OFF".
(
pg. 23, 28)
Time code
Set "TIME CODE" to "ON" or "OFF".
(
pg. 23, 28)
Indications other than date/time and time code
Set "ON SCREEN" to "OFF", "LCD" or "LCD/TV".
(
pg. 23, 28)
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(
pg. 13)
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power Switch to "A" or "M", then set
your TV to the appropriate input mode.
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
pg. 20)
Advertisement
Table of Contents
