Scheduled Maintenance; Troubleshooting Guide - Genie DirectLift 2060 Operation And Maintenance Manual

MAINTENANCE
A Monthly:
• Door springs and door hardware:
– Oil door roller, bearings, and hinges using silicone
lubricant or light oil .
WARNING:
Do not operate door automatically or manually if springs
are broken . Contact a Genie Factory Authorized Dealer for
service or call Customer Service at 1-800-35-GENIE .
• Balance Door .
– Close door .
– Release Carriage Assembly from Rail Assembly by pulling
the Emergency Release Knob towards the door .
– Raise door manually 3'- 4' and verify that door stays at
that position . See Check Step 2 on page 4 .
NOTE
When the door is 3' - 4' above the ground, the door
should stay open . Slight movement is acceptable . If
the door moves too much, contact a Genie Factory
Authorized Dealer for service or call Customer Service at
1-800-35-GENIE.
– Reattach Carriage Assembly to Rail Assembly:
a . Pull the Emergency Release Knob toward
Power Head .
b . Close door .
• Contact Reverse Test.
– Perform Adjustment 2 on page 8 .
TROUBLESHOOTING
Source (Red LED)
ON
OFF
OFF
2 BLINKS, Pause
(Repeat)
2 BLINKS, Pause
(Repeat)
3 BLINKS, Pause
(Repeat)
4 BLINKS, Pause
(Repeat)
10
Safe-T-Beam® System Self-Diagnostic Troubleshooting
Sensor (Green LED)
ON Normal operation
• Power Head not powered
OFF
• Wiring from Power Head bad
• Wiring to Source missing or bad • Check wiring
ON
• Power has been interrupted
• Beam not aligned
ON • Beam obstructed
• Sensor defective
• Wire to Sensor missing or bad
OFF
• Sensor defective
• Sensor receiving interference
ON
• Source not sending pulses
ON
• Source defective
If the door fails to reverse on contact with the board,
adjust the Close Force Control as specified in Set Limit
Switches and Force Controls on page 7 & 8 . If the Opener
still fails, contact a Genie Factory Authorized Dealer for
service or call Customer Service at 1-800-35-GENIE .
B Yearly:
• Wipe off old excess lubricant from Drive Screw .
• Lubricate Drive Screw with Genie Lubricant (GLU-3)
Use ONLY Genie Lubricant (GLU-3) . Other lubricants
may damage the Opener .
GLU-3
Lubricant
FCC AND IC CERTIFIED
All devices comply with Part 15 of the FCC Rules .
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, includ-
ing interference that may cause undesired operation .
C As needed
• Replace lightbulbs. (See page 9)
Possible Problem
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
WARNING:
NOTE
Solution
None required
• Check breakers, fuses, plugs
• Check wiring for obvious shorts
• Remove power and reapply
• Check Source, Sensor alignment
• Check for obstruction
• Contact Customer Service
• Check wiring
• Contact Customer Service
• Determine source of interference
• Check for interference from sun-
light or a source unit on an
adjacent door
• Contact Customer Service
• Contact Customer Service
• Contact Customer Service