Table of Contents
Advertisement
1. Battery
replacement.
, To open, gently push straight out on battery
cover lock tab as shown. (Fig. 8-1).
, Slide open battery cover.
- Remove old battery.
, Make sure new battery is facing proper direction
(Match battery polarity with symbols inside
battery housing) (Fig. 8-2).
- Recommended
replacement
battery type:
Alkaline A23, 12 volt.
, Slip new battery into place.
-Slide
battery cover until it clicks shut.
, Operate
remote to make sure it is working
properly. (No re-programming
is needed.)
2. Visor
clip.
(The visor clip may come already installed.)You
will have to install the visor clip if you choose to
attach your remote to the car visor.
, Slide visor clip into back of remote control.
-It will snap into place (Fig. 8=3).
1. Light bulb.
, Recommendations.
-Do
NOT use a short neck bulb.
-Light
bulbs should be no more than 60 Watts.
- Use a heavy duty service
bulb for longer life.
, Screw 1 bulb into each socket.
2. Lens.
, Select a white (lamp) cover.
, On the power head end nearest the garage
door, line up lamp lens tabs on power head with
corresponding
slots in lens (Fig. 9-1).
, Slide lens onto power head. Make sure the tabs
are fully engaged into lens slots (Fig. 9-2).
, Repeat for rear lens on power head.
, Plug power cord back into electrical outlet.
, Test lamp operation.
4
PN# 37026500123
05/15/2009
Hide quick links:
Advertisement
Table of Contents
