Argent Data Systems OpenTracker USB User Manual page 33

OpenTracker USB User's Manual
STATUS <0-255>
Status packets are sent every n transmissions, or if set to 0, status text is
sent as part of the position packet.
SYMBOL <1-2 characters>
APRS symbol character, optionally preceded by symbol table or overlay
identifier.
TELEMETRY on|off
Enables transmission of telemetry packets.
TEMP on|off
Enables transmission of temperature readings from the on-board
temperature sensor.
TEMPADJ <-128 to 127> (degrees C)
Offset for temperature sensor in degrees C.
TIMEHMS on|off
Sets timestamp mode to hour/minute/second when enabled. Default is
day/hour/minute.
TIMESLOT on|off
Force position packets to be transmitted only in designated time slots,
expressed as the number of seconds from the start of the hour to the first
transmission.
TIMESTAMP on|off
Report time information in the position packet.
TRACE on|off
When trace is on, each received raw packet is output in hexadecimal on
the active console port.
TXDELAY <0-255>
Delay between start of transmission and start of data. This setting should
be set to the minimum value that allows reliable reception of transmitted
packets. An excessively high
Each unit is one character time – 1/150 second at 1200 baud.
setting wastes channel capacity.
TXDELAY
31
(local only)