Argent Data Systems OpenTracker USB User Manual page 26

OpenTracker USB User's Manual
CDINVERT on|off
Inverts carrier detect input polarity.
CNTRESET on|off
Causes counter to reset with each transmission. See accessory port
information.
COMMENT <string>
Sets beacon text / comment string, up to 64 characters.
COMPRESS on|off
Enables Base91 compressed format for position transmissions.
CONFIG 1|2
Selects configuration profile to modify.
CONVERSE
In converse mode, text entered at the console is transmitted when the
ENTER key is pressed. Hit CTRL-C to exit. The command 'K' may also
be used to enter
COUNTER on|off
Transmits counter value in status text.
CUSTSYM on|off
Enables the use of custom symbols if they have been uploaded to a
compatible Garmin GPS receiver (using the Garmin xImage utility).
CWBEACON <text>
Sends <text> as a Morse code beacon.
DAO on|off
Enables transmission of the !DAO! extended-precision construct. This
provides an extra digit of precision over the standard APRS position
format, but results in a longer packet and may not be supported by all
APRS clients.
DEVLIST
Lists addresses of all connected 1-wire devices.
mode.
CONVERSE
24
(local only)
(local only)
(local only)
(local only)