Scanner Cloning - Radio Shack 20-163 User Manual

5. Press FUNC, then MODE.
6. Use the  or  to select the desired CTCSS or DCS code.
You can enter the code manually. The scanner automatically
fills in the code. See Appendix B for a list of codes.
7. Press ENT.
To save a CTCSS or DCS code:
Press ENT while the code appears.

Scanner Cloning

You can transfer the programmed data to and from another PRO-163
(or PRO-164) scanner using a connecting cable which has 1/8-inch
stereo (TRS) phone plugs on both ends (not supplied).
You can also upload or download the programmed data to or from
a PC using an optional USB cable and application software available
through your local RadioShack store. The application software is also
available online at www.starrsoft.com and www.scancat.com.
To clone the scanner data:
1. Turn on both scanners.
2. Connect the connecting cable to each scanner's PC/IF jack. **
CLONE MODE ** appears.
3. Press . "Confirm to send data?" appears.
4. Press 1 to send the data to the other unit or press any other key
to cancel.
5. To exit the clone mode, remove the cable.
"CLONE MODE Incorrect Model" appears if you connect a
scanner other than a PRO-163 (or PRO-164).
1