Accessory Storage - General 15-220 Setup And Operation Manual

General oscillating spindle sander setup and operation manual
Table of Contents

Advertisement

ACCESSORY STORAGE

SPINDLES
Place the drums into their storage space on the right
side of the machine.
INSTALLING SPINDLES ON THE MACHINE
Note: Reverse threads are used to attach the spindle to the machine.
Make sure that the switch is in "OFF" position and that the power cord is unplugged.
If installed, remove the table insert to allow better
access the spindle seat.
LOOSEN
TIGHTEN
Step 2
Using the two 17 mm wrenches tighten the spindle no more than another 1/2 turn.
NOTE: Do not overtighten the spindle in the seat or it may be very difficult to take off later.
BEFORE STARTING THE MACHINE:
Make sure the spindle is securely installed onto the arbor.
Make sure that the corresponding table insert is installed. See the accompanying SELECTION GUIDE (page 10) to
select the correct INSERT TABLE for the spindle being used.
TABLE INSERT PLATES
Store the table insert plates in the storage slots on the
left side of the machine.
Step 1
Select the desired spindle and while holding the
spindle seat in place with a 17 mm wrench, screw the
threaded end into the spindle seat counter clockwise
(reverse threads) until hand tight.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents