Table of Contents
Advertisement
• Because jewelry conducts electricity, wearing it
may cause dangerous electrical shock. Remove all
jewelry (such as rings, watches, bracelets, etc.)
before working on this equipment.
• If you must work on this equipment while standing
on metal or concrete, place insulative mats over a
dry wood platform. Work on this equipment only
while standing on such insulative mats.
• Never work on this equipment while physically or
mentally fatigued.
• Keep the transfer switch enclosure door closed and
bolted at all times. Only qualified personnel
should be permitted access to the switch interior.
• In case of an accident caused by electric shock,
immediately shut down the source of electrical
power. If this is not possible, attempt to free the
victim from the live conductor but AVOID DIRECT
CONTACT WITH THE VICTIM. Use a nonconduct-
ing implement, such as a rope or board, to free the
victim from the live conductor. If the victim is
unconscious, apply first aid and get immediate
medical help.
• When an automatic transfer switch is installed for
a standby generator set, the generator engine may
crank and start at any time without warning. To
avoid possible injury that might be caused by such
sudden start-ups, the system's automatic start cir-
cuit must be disabled before working on or around
the generator or transfer switch. Always set the
Auto-Off-Manual switch to its OFF position before
working on the equipment. Then place a "DO NOT
OPERATE" tag on the transfer switch and on the
generator.
Table of Contents
Safety Rules ..................Inside Front Cover-1
Section 1 - General Information ................2
1.1
Introduction ................................................2
1.2
Equipment Description ................................2
1.3
Transfer Switch Ratings Decal ....................2
1.4
Transfer Switch Enclosure ..........................2
1.5
Safe Use Of Transfer Switch ........................2
Section 2 - Installation..................................3
2.1
Introduction to Installation ..........................3
2.2
Unpacking ....................................................3
2.3
Mounting......................................................3
2.4
2.4.1
2-Pole Mechanism ........................3-4
2.5
Connecting Start Circuit Wires ....................4
and Adjustments ..........................................5
3.1
Functional Tests & Adjustments ..................5
3.2
Manual Operation ........................................5
3.3
Transfer Switch Voltage Checks ..................6
3.4
Generator Tests Under Load ........................6
Section 4 - Notes ............................................7
Section 5 - Electrical Data ............................8
Parts Lists........................................................9
Section 7 - Warranty ....................Back Cover
Generac
®
Power Systems, Inc.
1
Advertisement
Table of Contents
