Producing Hot Water - DeLonghi EC610 Instructions Manual

EC610/615 UK 16-05-2002
fig. 22
fig. 23
fig. 24
fig. 25
fig. 26
Coffee Maker
16:26 Pagina 8
3. Check that the three holes shown in fig. 22 are not blocked. If
necessary, clean them with a pin.
4. Clean the steam delivery tube (carefully to avoid be burnt.
5. Screw the steam nozzle back on.

Producing hot water

1. Press the ON/OFF switch.
3. When the 'OK' light comes on, press the delivery switch (fig. 6)
and at the same time turn the steam knob in an anti-clockwise
direction (fig. 20); hot water will come out from the steam nozzle.
4. To stop the flow of hot water, turn the steam knob in a clock-
wise direction and press the delivery switch again (fig. 6).
Cleaning and maintenance
Cleaning the filter holder for ground coffee
About every 300 coffees, clean the filter holder for ground coffee
as follows:
• Remove the filter with the frother.
• Clean the inside of the filter holder. Never wash in a dishwasher.
• Unscrew the cap of the frother (fig. 23) by rotating in the direc-
tion indicated by the arrow on the cap.
• Remove the frother from the container by pushing it from the
cap end.
• Remove the gasket.
• Rinse all components and clean the metal filter thoroughly in hot
water using a brush (fig. 24). Make sure the holes in the metal fil-
ter are not blocked. If necessary, clean with a pin (see fig. 25).
• Replace the filter and gasket on the plastic disk as shown in fig-
ure 26. Ensure that the pin on the plastic disk is inserted into
the hole in the gasket indicated by the arrow in fig. 26.
• Replace the assembly into the steel filter container (fig. 27),
ensuring the pin is inserted into the hole in the support (see
arrow in fig. 27).
• Finally, screw on the cap.
fig. 27
8