Advertisement
testo bar 39 GB
9-06-2000 10:25
• If your coffee machine is equipped with a cap-
puccino nozzle, immerse the nozzle into the
milk down to the mark on the nozzle (fig. 22).
N.B.: Immediately after use, unscrew and rinse the
cappuccino nozzle to remove any milk
deposit (fig. 23).
• From time to time, use a pin to clean the holes
in the cappuccino nozzle (fig. 24).
PRODUCING HOT WATER
(to prepare tea, consommé, etc.)
• Swi tch th e machine o n by pressing the
"ON/OFF" switch (fig. 4).
• Wait until the "OK" pilot lamp lights (fig. 7).
• Place a cup or glass under the steam nozzle.
• Press the delivery switch and, at the same time,
open the steam outlet lever.
• Hot water will flow from the nozzle. As soon
as the desired quantity of hot water has been
obtained, close the lever and press the delivery
switch again.
• If more than 1 litre of water is used, wait at
least 5 minutes before drawing hot water
again.
ELECTRICAL CONNECTION (UK ONLY)
A)
If your appliance comes fitted with a plug, it will incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut off
from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after remo-
ving the fuse: do not insert in a 13 Amp socket elsewhere in the
house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be
protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with the fol-
lowing code:
Green and yellow:
Blue:
Brown:
Pagina 9
IMPORTANT
Earth
Neutral
Live
CLEANING AND MAINTENANCE
• Before carrying out any cleaning operations of
the exterior parts, switch the machine off,
remove the plug from the socket and leave the
machine to cool.
• Do not use solvents, detergents or abrasive
products to clean the machine. A soft damp
cloth is sufficient.
• Clean the filter-holder, filters, drip tray and
water reservoir regularly.
• Do not immerse the appliance in water.
DESCALING
It is advisable to de-scale the appliance every 4 -
8 months, depending on the hardness of the water
and the frequency of use. De-scale using water
and vinegar as follows:
• Fill the tank with water, diluting 100cc of vine-
gar in it.
• Operate the machine as though making coffee
until the tank has been emptied, then rinse.
• Repeat the operation with water only for 2-3
tanks, rinsing until there is no longer any smell
of vinegar.
Descaling with other substances may be
hazardous to your health.
If the plug is a moulded-on type, the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to BS
1362. In the event of losing the fuse cover, the plug must NOT be
used until a replacement fuse cover can be obtained from your nea-
rest electrical dealer. The colour of the correct replacement fuse
cover is that as marked on the base of the plug.
B)
If your appliance is not fitted with a plug, please follow the instruc-
tions provided below:
As the colours of the wires in the mains lead may not correspond with
the coloured markings identifying the terminals in your plug, proceed as
follows:
The green and yellow wire must be connected to the terminal in the plug
marked with the letter E or the earth symbol
green and yellow.
The blue wire must be connected to the terminal marked with the letter
N or coloured black.
The brown wire must be connected to the terminal marked with the letter
L or coloured red.
or coloured green or
9
Advertisement
