Setting The Timer; Electrical Connection; Programmed Mode - DeLonghi PAC 46 Instruction Manual

GB-5751010700 15-01-2004

ELECTRICAL CONNECTION

Before plugging in check that:
• the mains supply corresponds to the
power supply shown on the rating plate;
• the socket and the mains lead correspond
to the power requirements of the applian-
ce;
• the socket is suited to the plug, otherwise
have the socket replaced;
• the socket is properly grounded.
The manufactures cannot be held responsi-
ble for any damages due to failure in fol-
lowing normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.
SETTING THE TIMER (if supplied)
The programmer/timer
must be set to the exact time. If for example
it is 4.00 pm. (16.00), turn the dial in a clockwi-
se direction (following the direction of the
arrow) until the number 16 is lined up with the
triangular pointer (the arrows indicates 4:00
P.M. approximately ).
N.B.: Never turn the dial in an anti-clockwise
direction!
The timer is in effect, an electric clock and
works only if the plug is connected to the
power supply. Whenever the plug is discon-
nected or there is a power failure, the pro-
grammer stops (the clock is then "slow") and
must be re-set.
16:33 Pagina 21

Setting the timer

14
, like all clocks,
20
pointer

PROGRAMMED MODE

1) Set the operating times by pushing out the
notches on the dial corresponding to the
period required (each notch represents 15
mins.)
2) Press the TIMER key
15
will come ON.
3) Make sure that the timer indicates the cor-
rect time (see instructions on setting).
operating time
Funzionamento
4) Select the desired function as shown in the
chart overleaf.
N.B.: To override the programmed operating
times, simply press the ON/OFF key
timer signal lamp ON will go out)
13
, the signal light
(the
13
21