Advertisement
At this point, the system passes on to setting of the second automatic
programme controlling the heated rail (" 2" appears on the right of
the display).
The programming procedure is as described above for P1.
At the end of programming, the word "AUTO" appears at the top of
the display and the "Timer on" indicator light comes on to indicate
that the appliance is ready to operate at the programmed time.
Programming the convection heater: follow the same procedure as
described for the heated rail.
Notes:
• If no OFF time is set, the system automatically takes "00:00";
• If no ON time is set ("--:--" is displayed), the system automatically skips setting of the OFF time
and the programme can be considered "not active".
• After programming, if at least one automatic programme is active, "AUTO" and the "timer
on" LED light come on.
The symbols of the programmed elements appear on the right (heated rail only, convection
heater only or both).
Each symbol may be:
• STEADY when the current time is within at least one of the programmed time bands (appli-
ance in operation, red "ON" indicator light on);
• FLASHING if the current time is not within any of the programmed time bands for the element
in question, the system is thus in standby "waiting" for the time to coincide with the ON time.
• You can switch from automatic to manual mode at any time by pressing the "MAN" button
("MAN" is displayed and the appliance is off).
• After programming, if no automatic programme is activate, the appliance returns to manual
mode and "MAN" and "0" are displayed.
MAINTENANCE
Before carrying out maintenance or cleaning, always make sure the appliance is unplugged
from the mains. This appliance requires no particular maintenance. To clean, avoid using abra-
sive cloths or equipment which could damage the appearance. Use a cloth moistened with warm
water and/or neutral detergent only.
15
Pr
ess the "Clock
Pr
ess the "Clock
set" + "P1" button
set" + "P1" button
AUTO
AUTO
Advertisement
