Page 1
5721009100 4-12-2003 11:57 Pagina 1 RADIANT HEA RADIANT HEA...
Page 2
5721009100 4-12-2003 11:57 Pagina 2 RADIANT HEATER Technical Data Type Category Maximum Medium Gas pressure Input Input Input see rating label 4.20 2,85 1,50 2,8 kpa This appliance is designed to operate with LPG at nominal pressure: 2,8 kpa. For a correct gas combustion the required air quantity is 8,4 m WARNINGS ALWAYS use heater in accordance with instructions.
Page 3
5721009100 4-12-2003 11:57 Pagina 3 ASSEMBLY 1) Place the gas cylinder in the gas cylinder compartment Gas cylinder compartment and connect the regulator to the cylinder as shown on page 3. 2) To fit the backcover, insert the two tabs located on the left-hand side of the backcover into the corresponding slots in the cabinet.
Page 4
5721009100 4-12-2003 11:57 Pagina 4 Pressure regulators, rubber tubes and clips CHECK that tubing is completely over the nozzles at each end of the tubing and that it is held firmly in place by tube clips (See fig.9). Check the expiry date and state of the rubber tube regu- larly.
Page 5
5721009100 4-12-2003 11:57 Pagina 5 OPERATING INSTRUCTIONS Lighting the heater 1. Turn on the gas at the gas bottle tap. 2. FROM « ● » POSITION, fully depress the control knob for 10 seconds and turn to (Small Flame) position. (If pilot flame does not ignite return to starting position and repeat).
Page 6
5721009100 4-12-2003 11:57 Pagina 6 MAINTENANCE Wipe your appliance with a soft damp cloth and only when it is switched off, cold and unplugged. Do not use solvents or abrasives detergents. Check that there is no dust blocking the air inlet or outlet grids. Clean using a vacuum clea- ner.
Page 7
5721009100 4-12-2003 11:57 Pagina 7 5721009100/ 12.03...
Need help?
Do you have a question about the SRI and is the answer not in the manual?
Questions and answers