When using electrical appliances, basic safety precautions should always be followed, including the following: • Read all instructions. • Do not touch hot surfaces. Use handles and knobs. • To protect against fire, electrical shock and personal injury, do not immerse cord, plug or appliance in water or other liquid.
Read this instructions manual carefully before installing and using the device. Only by doing so will you be able to obtain the best results and the maximum safety of use. DESCRIPTION OF THE DEVICE The terminology below will be used throughout the pages that follow.
Page 8
(fig. 6) and immediately afterwards press the coffee delivery switch (fig. 7). Let the water exit until the “ESPRESSO OK” light goes off; then stop the delivery by pressing the coffee delivery switch again. 4.Empty the cup, wait until the “OK” pilot light comes on again and repeat the whole operation one more time.
GB 7-11-2000 14:32 Pagina 9 not possible to remove the cap because the threads do not grip. Therefore, to fill the boiler, it is necessary either to wait until all the water in it is used up or until the boiler has cooled.
Page 10
that the hole marked by the B arrow is not plugged. • Once clean, all the parts must be re-assembled in the correct manner. In particular, make sure that the rubber mixer is inserted all the way in and that the red coloured foamer is inserted until a click is heard.
Page 11
PROBLEM Espresso coffee no longer • Lack of water in the tank. comes out. • The holes in the filter holder spouts • The outlet of the espresso boiler is •The tank is badly inserted and the Espresso coffee drips from the •...
What Does This Warraty Cover? We warrant each Espresso Coffee Machine to be free from defects in material and workmanship. Our obligation under this warranty is limited to replacement or repair, free of charge at our factory or authorized service centers, of any defective part or parts there of other than parts damaged in transit, which shall be returned to us, transportation prepaid.
Need help?
Do you have a question about the BAR50 and is the answer not in the manual?
Questions and answers