Chapter 04
Using MDC
Configuring Settings for Multi Control
MENUm→
System
→
Multi Control
→ ENTERE
Assign an individual ID to your product.
Configuring settings for Multi Control
ID Setup
•
Assign an ID to a set. (Range: 0~99)
Press ▲/▼ to select a number, and press E.
ID Input
•
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
MDC Connection
•
Select a method to connect to MDC to receive the MDC signal.
RS232C MDC
-
Communicates with the MDC via a RS232C MDC cable.
RJ45 MDC
-
Communicates with the MDC via an RJ45 MDC cable.
54