Table of Contents
Advertisement
ASSEMBLY
Your generator
requires some assembly and is ready for
use at_er it has been properly
serviced with the
recommended
oil and fuel.
If you have any problems
with the assembly
of your
generator,
please call the generator
helpllne
at
1-800-270-1408.
IMPORTANT:Any
a_empt to run the unit before it hzs
been serviced with the recommended
oil will result in an
engine failure.
Remove
Generator
From
Carton
I,
Set _rton
on a rigid flat surface with "This Side Up"
arrows pointing upward.
2.
Carefully open top flaps of shipping car_on. Review
"Cold Weather
Operation"
on pzge 10.
3.
Cut down corners at one end of _rton
from top to
bo_om and lay that side of _rton
down tla=
4.
Remove all pacl(Tngmaterial, car_on fillers, etc.
S.
Remove the generator
from the shipping carton.
Install Wheel
Kit
The wheel Idt is designed to greatly improve the por_bili_
of your generator.
NOTE:Wheel
kit is not intended for over-the-road
use.
You will need a socket wrench with I/2" or 13ram socl(ets
and a needle-nose plier to instil
this kit,
Refer to Figure
I and install the wheel
kit as follows:
I.
Place the bo_om of the generator cradle on a flat,
even surface.Temporarily
place unit on bloc_ to e_se
assembly.
2.
Slide zxle through both axle mounting brackets on
cradle frame, as shown in Figure I.
3.
Slide a wheel over the axle.
NOTE:
Be sure to install both wheels with the air
pressure valve on the outboard side.
4.
Place the e-ring onto the groove in the axle.You may
add the flat washer if desired.
NOTE:
Use retaining pins instead of e-clip, if appli_ble.
5.
Place one end of the needle nose pliers on the bot_m
of the axle and the other end of the pliers on top of
the e-ring. Seat the e-ring by pressing the pliers closed.
6.
Repeat step 3 through 5 to secure second wheel.
II
vv
Advertisement
Table of Contents
