Comtrend Corporation CT-5365 User Manual page 53

Mark IP Type Of Service
Mark 802.1p if 802.1q is enabled on
WAN
SET-1
Physical LAN Port
Protocol
Source IP Address
Source Subnet Mask
Source Port (port or port:port)
Destination IP address
Destination Subnet Mask
Destination Port (port or port:port)
SET-2
802.1p Priority
If the Enable Differentiated Service Configuration checkbox
some additional fields will display, as shown below.
Select either: Normal Service, Minimize
Cost, Maximize Reliability, Maximize
Throughput, Minimize Delay
Select between 0-7. The lower the digit
shows the higher the priority.
Select between eth0, Wireless and
Wireless_Guest.
TCP, TCP/UDP, UDP, or ICMP.
Enter the source IP address.
Enter the subnet mask for the source IP
address.
Enter source port number or port range.
Enter destination IP address.
Enter destination subnet mask.
Enter destination port number or port range.
Select between 0-7. The lower the digit
shows the higher the priority
52
is selected,