Usb Setup; Fader Replacement; Specifications - Gemini PS-626USB Operation Manual

CONTROLS:
(CONTINUED)
13
The
individual channel depending on how low or high its input level is
14
The
ing you a choice frequencies (
and
higher or lower the 3 separate frequencies till the sound of the music
program is appropriate for your listening environment.
15
After you have chosen which input you will use with the
the corresponding
just the volume for that particular
16
The fader adjustment switches allow you to change the functionality
of the fader. The
the fader so it works in
nel (2) on the right. The
fader settings, positioning the switch to the left will give you a
gradual and positioning the switch to the right will give
you a quick
17
The allows you to mix evenly from one source to an-
other. On the
all (5) channels. The
movable and if the need arises can be replaced.The
)
stainless steel rails that allow the slider to ride smoothly and accu-
rately from end to end can be purchased from your local
dealer.
18
The has a
decibel levels of the
19
The has two display modes, in CUE mode it will display
the level of the channel you are cueing, in MASTER mode it displays
the main MASTER output.
20
The
output
21
The
22
The
volume.
19 23
The
nel you wish to monitor in your headphones.
allows you to boost the signal of each
adjust the tone of each
) to adjust , from
,you can use the adjustment knobs to
will allow you to ad-
.
switch when in the position will flip
ie. channel (1) on the left and chan-
selector lets you choose between two
.
The is assignable between
on the
, which has internal dual
that allows you to monitor the
and output.
knob adjust the volume of the
determines the mix between the chosen
and the mix.
adjusts your
allows you to choose which chan-

USB SETUP:

Open the
control panel folder click on the
, when the
click on the
the
L by giv-
on and you are ready to use the
Under the
window choose the
Repeat the procedure for the
work with the

FADER REPLACEMENT:

1. UNSCREW THE FADER (B)
SCREWS. DO NOT TOUCH INSIDE
SCREWS (C) CAREFULLY RE-
MOVE OLD CROSS FADER AND
UNPLUG CABLE (D)
2. PLUG IN THE NEW CROSS
FADER INTO CABLE (D) AND
PLACE BACK INTO MIXER.
is also re-
(
3. SCREW THE CROSS FADER TO
MIXER WITH THE FADER PLATE
SCREWS (B)
4. REPLACE THE FACE OF THE MIXER AND SCREW THE FOUR SCREWS
BACK IN AND REPLACE THE FADER KNOBS.

SPECIFICATIONS:

.
Phono............................................................................3mV,47 K Ohm
Line.........................................................................150 mV, 27 K Ohm
MIC.............................................................1.5 mV, 1 KOhm Balanced
Max..........................................................................20V Peak-to Peak
Rec............................................................................225 mV, 5 K Ohm
Frequency Response.........................................20Hz - 20KHz +/- 2dB
Distortion..................................................................................< 0.02%
S/N Ratio...................................................................Better than 85 dB
Headphone impedance..............................................................8 Ohm
Power Source ..............................................................AC 15v 500mA
Unit dimensions............................................................10" x 3.3" x 12"
.............................................................................(254 x 84 x 304 mm)
Weight.........................................................................6.5 lbs (2.94 kg)
PS-626USB
menu and go to
pane, then under
as a
menu open
choose the icon, once in the
pane and under
select
pane, now your
.
, once in the
window opens
choose
then you just click
with your .
, and in
.
is ready to
5