Table of Contents
Advertisement
Quick Reference Guide
F
UNCTIONS
Sending
an SOS
Location
Request—
from a phone
Activating
Geofence
Deactivating
Geofence
Answering
Call
Ending Call
Calling out
Volume
Control
GSM/GPS Test Press "Volume/Test" Button to test for GSM (cellular) and GPS
Hands-free
Worldwide
monitoring
and tracking
Low battery
Charging
Car/Home
charger
14
User Manual.indd 14
Press and hold the SOS Button for a minimum of 4 seconds. The Signal
light will be green while the unit reports the emergency to the control
panel and to the speed dial numbers that you set.
Mobile phone numbers that have been preset and stored in Speed
Dial Buttons 1 and 2 can call and request location information from
the unit. The Gemini recognizes these numbers and automatically
hangs up after one ring. The location of the Gemini will then be sent
to the phone that requested the location.
Press "G" Button for 4 seconds, the unit will beep once and report to
the control center and automatically activate the Geofence function.
You can also set and define Geofence boundaries by logging on to
your account at www.geminitracking.com.
Press "G" Button for 4 seconds, the unit beeps twice and deactivates
the Geofence. You can also deactivate the Geofence by logging on to
your account at www.geminitracking.com.
Any phone can be used to call the unit, and the unit will notify the user
with music ring. To answer the call, simply press the "Answer" Button.
User can end the call by pressing the "Hang-up" Button.
Users can call any preset number (1, 2, 3) by simply pressing the
appropriate Speed Dial Button.
Press "Volume/Test" Button to adjust sound level during a phone call.
(Volume adjustment sequence: Medium → High → Low)
reception while in normal standby mode. Green light stays on for 4
seconds if GSM (cellular) signal is OK (no green light if no GSM signal)
Blue light stays on for 4 seconds if GPS signal is OK (if no GPS signal.
then signal light blinks blue for 20 seconds).
Earphone is included for user to answer the phone hands-free.
With the European GSM communication module, to use worldwide
without distance restrictions
Signal light is red and says on. A message is sent to the control panel
that the unit needs to be charged.
Signal light is orange and stays on when the unit is charging while in
the "Off" position, and goes out if the unit is fully charged.
Using DC 12V charger (for car) and AC 110V–240V charger (for home)
to charge the unit.
O
PERATIONS
2/2/06 10:27:54 AM
Advertisement
Table of Contents
