Roughing-In References For Recess Type Installations - American Standard 2664 Installation And Operation Manual

ROUGH-IN REFERENCES FOR RECESS TYPE INSTALLATIONS
TYPICAL TILE FLANGE INSTALLATION
WOOD
STUD
STUDS
WATERPROOF DRYWALL
OR CEMENT BOARD
TILE
ROOFING NAIL
SEALANT
TUB
STRINGER FULL LENGTH
STEEL
STEEL
STUDS
STUD
WATERPROOF DRYWALL
OR CEMENT BOARD
TILE
SEALANT
TUB
SECURE THE BATH TO THE STUDS AS SHOWN
FOR WOOD OR STEEL STUD CONSTRUCTION.
C
E
LEVELING
NOTE:
STRINGERS
FRONT EDGE
OF BATH MUST
BE SUPPORTED
BY STUD WALL OR
AMERICAN STANDARD
APRON KIT
UNLESS AN ACCESS OPENING OF AT LEAST 12" x 24" (305 x 610mm)
IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED.
1" x 3" (25 x 76mm) WOOD
WASHER
4" (102mm)
DRYWALL
SCREW
1" x 3" (25 x 76mm) WOOD
STRINGER FULL LENGTH
24"
(610 mm)
ACCESS PANEL MUST BE LOCATED
ON THE SAME SIDE AS THE MOTOR.
ALLOW OPEN FRAMING ON
PUMP/MOTOR END FOR SERVICE.
ACCESS PANELS NOT
REQUIRED FOR BATH TUBS
TYPICAL TILE BEAD INSTALLATION
TILE
BEAD
STRIP
1" x 4" (25mm x 102mm) not for support
NOTE: Tile bead kit not included and must
be purchased separately.
5
12"
(305 mm)
TILE
WALLBOARD
SEALANT
BATH
ADHESIVE
LEVELING STRINGER
754532-100 Rev. A